You can put the shoulder in the smoker fat side up or down, I’ve had good results with either way of doing it. However in general you want the fat side up so the juices baste the meat while cooking.
Do you cook pork shoulder fat side up in oven?
Place pork, fat side up, in a roasting pan or large Dutch oven with 1/2 cup water. Roast until some fat has rendered, about 45 minutes. Remove pan from oven and reduce oven temperature to 350 degrees. Tightly cover pan with foil or a lid.
Should the fat side be up or down on a pork roast?
In most cases you can’t go wrong by positioning the fat layer on top. As the fat melts, the juices drip down and baste the sides and bottom of the meat. This helps protect the fat-free surfaces of the meat from drying, and adds flavor.
How do you use pork fat trimmings?
You can use pork trimmings to make lard, which is rendered pork fat; or cracklings, which are the bits of fat and meat that don’t render completely. Lard is a choice ingredient when making fried chicken, home fries, doughnuts, or pastry crust.
Should I trim the fat cap on pork shoulder?
The fat cap can contribute flavor and texture to the pork, but it’s important not to overdo it. We prefer to trim the fat cap to about 1/4 inch, then use the trimmings as a seasoning for other dishes. You can use what’s left of the fat cap to add moisture to the pulled pork after cooking.
Does the fat side up or down?
Advocates of cooking fat side up claim that the fat will “melt” into the meat, making it moist and juicy. However, this is a myth. The truth is that meat cannot absorb fat. Instead, the fat melts and runs off the meat into the drip pan, taking any seasoning you may have put on the meat with it.
Should I cook a roast fat side down?
In most cases, you should cook a rump roast with the fat side up. As the roast cooks, the fat melts and runs down the sides of the meat to baste it and provide flavor and moisture. If the fat is sitting on the bottom of the pan, you won’t get the same benefit.
How do I render down fat?
Place the fat into your pan, then add enough water to cover the bottom of the pan by about half an inch. Place the pan over a medium flame, until the water starts to boil, then turn heat down to low. Cook gently for 1-2 hours, stirring every so often until most of the fat has rendered.
How do you render pork fat in the oven?
Preheat the oven to 300 degrees F. Cut the fatback into 1/4-inch cubes and put it into a 6 to 8 quart Dutch oven. Add the water. Put in the oven, uncovered and stir every 30 to 40 minutes, pressing the pieces against the pan in order to help them melt.
Do you leave the fat on pulled pork?
As it cooks, the flavorful juices and drippings infuse into the sauce, making it even more rich and tasty. Make sure to remove most of the fat that’s sitting on top so it doesn’t make the sauce too greasy. All of the liquid left in the vessel is then reduced until it becomes a thickened tomato-based barbecue sauce.
Do you put fat side down in a slow cooker?
When placing the roast in the slow cooker, does the fat side go up or down? Fat side up ALWAYS on any meat that you are slow roasting. Placing the fat side up provides a steady source of moisture and evenly bastes the roast all during the cooking time.
Why would you leave the fat cap on during cooking?
The main reason for cooking with the fat cap down is many people feel doing so allows the fat cap to act as insulation, protecting the meat from the direct heat and will keep the meat from drying out.